Introduction + Concept Art Card with Lights Aglow Suite Collection

Hello there! Thank you for joining me today for an introduction to the fabulous Lights Aglow Suite Collection with a Concept Art project.

I label this as a super suite because this is one of our large suites with 2 stamp sets, 2 sets of die-cuts, 3 designer series paper packs, ribbon, and a large package of jewels.

These products are stunning in person with endless creative opportunities that I’m really looking forward to unpacking as the holidays near.

The Lights Aglow Suite Collection details are below.

I started out with an A2 Cherry Cobbler card base and cut the Cherry Cobbler Lights Aglow 6 x 6 Specialty Designer Series Paper to size as below that I adhered to the card base with liquid adhesive.

The Gold Glimmer Specialty Paper was cut to size and adhered with Tear & Tape, which is the best adhesive to use with our Glimmer cardstock.

I cut my Very Vanilla CS to size and used the large dot die from Twinkling Lights Dies to cut in twice so the glimmer paper would show through the dots.

I stamped the large star garland image in Cherry Cobbler twice above the die as shown. Soft Succulent was used for the dot garland stamping down in full strength first then stamped off.

The sentiment from Brightest Glow Stamp Set was stamped in Cherry Cobbler with 2 gold Festive Pearls on each side to embellish.

The image panel was adhered to the gold glimmer with Tear & Tape.

This is a very easy and attractive card to mass produce, which is relatively flat and simple send in the mail.

I hope you enjoyed today’s project and please let me know if you have any questions.

Thank you for stopping by for a visit and have a great day!

1. Card base: A2 top-folding 4-1/4 x 5-1/2, Very Vanilla Thick CS.
2. L/R DSP panels: 3/4″ x 5-1/2, Lights Aglow Specialty Designer Series Paper.
3. Glitter panel: 3-1/2 x 5-1/2, Glimmer Specialty Paper.
4. Image panel: 3 x 5-1/2, Very Vanilla Regular CS.